While you are out cutting wood, you may end with a stuck chainsaw in the event if you are not cautious enough. There are various techniques that individuals use to keep the chainsaw from getting stuck. People usually use the crosscutting process of cutting the wood; with this method, you will be able to get the job done without the chainsaw getting stuck.
Before you begin crosscutting the log, ensure that you are not anyplace near a slope, you additionally need to take the essential measures. Make sure that you have safety glasses on, too; you must have protective shoes and safety gloves on to keep you safe.
Step by step instructions to crosscut with a chainsaw
In any case, hold the front handle with your thumb. Run the chainsaw at max speed before making the main cut. While you are working, it is prescribed to stand away from the chainsaw at a diagonal angle. Abstain from standing directly behind the chainsaw to maintain a strategic distance from injury from kickoff.
To keep the trunk from parting it is advised to cut 33% of the trunk’s diameter across. This cut ought to be made on the side of the trunk that will be exposed to the most pressure. This zone of influence is additionally where the chainsaw’ bar will, in all likelihood become pinched.
When the first gathering cut has been made, you can proceed from the opposite side of the trunk until the two cuts meet. To help encourage the felling procedure, you can use a felling wedge.
Crosscutting logs that are supported at both ends
If both ends of the log are supported, then it is best to avoid cutting it from above. When both ends are being supported, the stress and tension are placed in the centre of the log. Cutting from above will allow the pressure to pinch and trap and the chain or bar.
Begin by making a cut on the top of the log that is an inch or two deep. It will help prevent the wood from splitting. Next, directly beneath where you made this cut, you can use your chainsaw to cut from the underside of the log and work up until you meet the top cut. Stand back diagonally from the trunk to prevent the dense wood from crushing your feet as it falls.
Crosscutting logs that are supported at one end
If only one end of the log that you are crosscutting is supported, then the tension and stress will be focused on the underside of the wood. It means that the crosscutting should be performed from above to prevent the chainsaw from becoming pinched or stuck.
To prevent the trunk from splitting while performing the crosscut, first, make a shallow cut of one to two inches on the underside of the log. Using this as a guide, begin to cut your way through the wood from the upper side until the two cuts meet—standoff to the bottom of where you expect the log to fall to avoid injury.
How to free a pinched chainsaw
It tends to be hard to turn out to be actually where the tension and stress will be on individual logs and trunks. Misinterpreting where the pressure is can make the chainsaw become trapped. It is never a smart thought to shake your chainsaw while the motor is as yet running. To do so could cause hopeless harm your chainsaw and possibly deadly injury to yourself or others.
The ideal approach to free a stuck chainsaw is to use a felling wedge or a crowbar to tenderly lift the weight and strain of the tree off of your chain and bar. Before endeavouring to do this, the motor ought to be turned off to keep the chain from coincidentally moving and causing harm or injury. While it tends to be disappointing, acting calmly and with exactness will have it free instantly by any stretch of the imagination.
Using a chainsaw intended for remote work can help limit the danger of your chainsaw from getting squeezed or caught.
Why crosscutting is significant
The crosscutting technique helps to prevent your chainsaw chain and bar from becoming trapped or damaged when felling a tree. By making the first cut when using this technique, you are effectively displacing the tension and preventing any accidental splits from occurring. By using a crosscutting method, you have better control over which direction you would like the tree to fall.
Hopefully, this article has helped you understand a lot about the subject.