To get the best cutting results, it’s fundamental that you have a suitable chainsaw chain. While the engine is a significant part that drives the cutter, the chain does the cutting. After some time, your chainsaw chain will start to dull, corrode, break, and so forth. Meaning you’re going to need to replace it or risk fatal injury.
Do You Need To Replace Your Chainsaw Chain?
The main chainsaw parts are involved in a guide bar, engine, and sprocket. As a chain becomes twisted and dull, it radically decreases the productivity of the machine. As you most likely know, chainsaws work at high RPMs, and these chain related issues can affect the safety of operation and cause lethal injury. For instance, kickback is considered to be the number one cause of chainsaw related injuries.
Factors to Consider When Replacing The Chainsaw Chain
When it comes time to change your chainsaw chain, you can refer to this guide on the best way to quantify your guide bar just as the pitch and gauge of your saw. A speedy method to check these measurements is to look at the chainsaw bar. Most bars will detail the pitch, gauge, drive links, and length. On the off-chance it doesn’t, consult your manual or measure them manually.
Your replacement chain must fit the guide bar. It’s also important to note that not all chains will provide all bars. Chains need to be the appropriate length to function safely.
Steps To Replace Chainsaw Chains Are As Follows-
This undertaking may appear to be overwhelming; however, it’s entirely simple to do. You will require the accompanying devices:
- Flathead screwdriver
- Socket Wrench
- Replacement chain
- Your chainsaw
Stage 1: Remove the Old Chainsaw Chain
Start by removing the side plate. To do this, you will need to remove the two nuts that hold everything together. Use your socket wrench/t-wrench to unscrew the nuts so you can gain access to the chain.
Note: If your chainsaw has a brake attached to the side plate, you should disengage it. On the off chance that you don’t, it very well may be somewhat hard to reinstall it.
Check how to shorten your chainsaw chain
Stage 2: Release the Chainsaw’s Tension
With the side, plate removed you can pull the nose of the guide bar away from the saw. It will make the chain release from the tensioner. The chain will get slack, and you will have the option to remove it.
Stage 3: Loosen the Tensioning Screw
The next thing is to find the tensioning screw. It is usually found inside the guide bar. When you discover it, loosen it with your flat head screwdriver a little so that the new chain will slip on easier.
Stage 4: Threading the Chain onto the Saw
When your chain is on the guide bar, you should string the chain onto the saw’s clutch drum. You have to ensure that all the drive links connect with the sprocket. When threaded, you have to adjust the bar by applying some pressure. You can do this by tenderly pulling the nose away from the chainsaw.
Stage 5: Put the Side Plate Back On
Ensure the guide bar is level and in the correct position. Put the side plate back on the chainsaw and set the nuts back on with the socket wrench. Don’t fix the nuts yet. The guide bar should have the option to move a piece while the chain is attached to the correct tension.
Stage 6: Tighten Everything
Utilize the tensioning screw to add tension to the chainsaw chain. Once you’ve reached the correct tension, you can fix the nuts.
Final Thoughts
Know that you can sharpen your chainsaw chain a couple of times before replacing it. In any case, when it comes time to replace the chain, the guide above is genuinely clear. We’d recommend using gloves when handling the chain because the teeth can be rather sharp.
Hopefully, this article has helped you understand a lot about the subject.
